s3c2443.c

Go to the documentation of this file.

// SPDX-License-Identifier: GPL-2.0-or-later
 
/***************************************************************************
 *   Copyright (C) 2007, 2008 by Ben Dooks                                 *
 *   ben@fluff.org                                                         *
 ***************************************************************************/
 
/*
 * S3C2443 OpenOCD NAND Flash controller support.
 *
 * Many thanks to Simtec Electronics for sponsoring this work.
 */
 
#ifdef HAVE_CONFIG_H
#include "config.h"
#endif
 
#include "s3c24xx.h"
 
NAND_DEVICE_COMMAND_HANDLER(s3c2443_nand_device_command)
{
    struct s3c24xx_nand_controller *info;
    CALL_S3C24XX_DEVICE_COMMAND(nand, &info);
 
    /* fill in the address fields for the core device */
    info->cmd = S3C2440_NFCMD;
    info->addr = S3C2440_NFADDR;
    info->data = S3C2440_NFDATA;
    info->nfstat = S3C2412_NFSTAT;
 
    return ERROR_OK;
}
 
static int s3c2443_init(struct nand_device *nand)
{
    struct target *target = nand->target;
 
    target_write_u32(target, S3C2410_NFCONF,
             S3C2440_NFCONF_TACLS(3) |
             S3C2440_NFCONF_TWRPH0(7) |
             S3C2440_NFCONF_TWRPH1(7));
 
    target_write_u32(target, S3C2440_NFCONT,
             S3C2412_NFCONT_INIT_MAIN_ECC |
             S3C2440_NFCONT_ENABLE);
 
    return ERROR_OK;
}
 
struct nand_flash_controller s3c2443_nand_controller = {
    .name = "s3c2443",
    .nand_device_command = &s3c2443_nand_device_command,
    .init = &s3c2443_init,
    .reset = &s3c24xx_reset,
    .command = &s3c24xx_command,
    .address = &s3c24xx_address,
    .write_data = &s3c24xx_write_data,
    .read_data = &s3c24xx_read_data,
    .write_page = s3c24xx_write_page,
    .read_page = s3c24xx_read_page,
    .write_block_data = &s3c2440_write_block_data,
    .read_block_data = &s3c2440_read_block_data,
    .nand_ready = &s3c2440_nand_ready,
};