OpenOCD and the Amontec JTAG Accelerator

Amontec released their JTAG Accelerator configuration for the Amontec Chameleon. The JTAG Accelerator is a high-speed EPP mode parallel port interface offering up to 70kByte/s download speed to target RAM using memory writes, and about 120kByte/s using the Debug Communications Channel (DCC).

4 Responses to “OpenOCD and the Amontec JTAG Accelerator”

  1. Vit Mares says:

    Is it possible to run OpenOCD with QUATECH SPP-100 PCMCIA Parallel port?
    Have you got any experience with similar alternative LPT ports please?

  2. Administrator says:

    I checked the quatech site, and they claim that their device should behave “exactly like a computer’s native parallel port”. It also seems that you can configure these devices to use one of the standard parallel port I/O locations (like 0×378). So basically yes, it should work.
    Especially the Wigglers require a parallel port that behaves “normal” – you’ll have to test this device to find out if it works.

  3. Radoslaw Szczygiel says:

    It is realy possible to download to RAM about 370Kbyte/s using DCC in EPP mode. I’m end writing Amontec JTAG Accelerator driver for project and it work very well and speedy.

  4. Administrator says:

    Thanks for your comment, I’ll look into this a bit closer. In my test I’ve never achieved more than about 160kByte/s.